Saturday, May 11, 2013

Audio Capacitors do have polarity!!! (IMO)

 Do audio capacitors have "polarity"???  I guess so!!!

 

Experiment all kind of caps and test the polarity when you mod a guitar (tone control) or a pedal, this worth a value so much. The sound changes, depending on the capacitor type and the polarity you use. In the mods is important to try out any capacitor, with the value desired, that you own, even if it is the same type. It is cheap, so buy a lot of then. Building tube amps, I prefer the orange drop and the PIO capacitors.

* I have used a strat with a 500k volume pot at the tests, to listen the highs easiest.

** I have used some tests described in internet too, as the noise test connecting the capacitor in the input of a simple guitar amp (with a help of a power AC cord near of the capacitor to generate noise).





tube amp capacitors




Behringer AM-400 and DR-400 input signal mod

Behringer Acoustic modeler AM-400 and Digital Delay/Reverb DR-400 input signal mod


The input signal circuit of the AM-400 and DR-400 are the same, try out the mod:


  • Change the input capacitor 22nF to 47nF (for more bottom) and remove the pF capacitor after a 10K resistor (for more open sound), see the picture:


* This will help the AM-400 annoying hiss (white noise) problem, caused by increasing the attack button to compensate the lack of treble. By removing the cutting capacitor, you won't need to increase the attack (so much) to obtaining more highs.






Tri-wah Rocktron mods


Mods:
  • True bypass using the original switch (first picture), no money needed.
  • Sweep range caps (try out values like 8n2F and 15nF - see the red circle in the second picture - they are selectable to be in parallel with a 10nF cap by the tri-wah switch).
  • Guitar cable inner wire in the bypass path (input jack - switch - output jack), use a good guitar cable part to keep the original input tone (I like the 0.5 mm cables).



True bypass adaptation schematic:
Sweep caps in red circle:


 

 

  

Bypass wire (black thick wire):





* Change the jumpers in the circuit board to make the necessary connections.
**  The GCB-95 schematic is quite similar.