Sunday, April 12, 2015

Boss Chorus CH 1 and Behringer UC200 Mod

Mods for more thicker effect options:

  • Add a toggle switch (on-off-on) to select the C18 values, this will change the delay time of the out of tune signal, before it is added to the guitar signal. The middle position will be off and only a 5pf (or 4,7pF) value is seeing by the circuit, no delay at all, the others positions will select two 0 to 100pF trimmers that can be adjusted as you wish, for a pleasant delay color. Adding more delay time, more thicker will be the chorus effect.
  • Optionally, reduce the value of C30 (or remove it) to upper the trebles, only in case of a dead tone problem.

*     In place of one trimmer, could be used the original 47pF capacitor.
**   Behringer have originaly  a 5pF in parallel to a 47pF (C18) capacitor.
*** The C18 mod is very famous in the internet foruns.

See the picture:



boss ch1 mod



*Use Boss schematic above to mod this Behringer stomp box.


Saturday, March 21, 2015

Boss Tremolo TR 1 and Behringer UT100 Mod

Mods for more tone options and balance the on and off stomp's volume:

  • Replace the R9 resistor from 10K to 18K (or more), to balance the on and off stomp volume. I've choosen 18K.
  • Add a on-off-on toggle switch to select the C4 values (or no C4), this will make a subdued, but perceptive, diference in the effect tone. The middle position will select none capacitor, the Boss TR1 came originally with 0,1uF cap and the Behringer came with a 0,68uF eletrolitic cap. You can select 0,1uF, 0,68uF and none capacitor, or try out others values.

See the picture:


Boss Tremolo TR 1 and Behringer UT100 Mod



*Use Boss schematic above to mod this Behringer stomp box.


Boss HyperFuzz FZ-2 or Behringer Super Fuzz SF300 Mod

Mods for a more pleasing distortion without the "octave" effect and adding the volume control in the boost mode:
  • Remove Q13 and its circuit to get the octave effect out, as the picture shows, its possible to remove the 1k resistor initially to test this mod.
  • Replace the 10K in Q14 base for a 1K resistor, to increase the stomp volume.
  • Jump the part of the mode switch and cut one lead, to add the volume control to the boost mode (see in the picture below).

See the picture:

FZ-2 SF300 MOD


*Use Boss schematic above to mod this Behringer stomp box.